Emaco Nanocrete
Emaco® Nanocrete R2
Emaco® Nanocrete R2 is a universal, single component, polymer modified, fast setting, repair, re-profiling and levelling mortar. Emaco® Nanocrete R2 is a ready-to-use material that contains special cements, well graded sands, carefully selected polymers and fibres to reduce shrinkage and improve physical and application properties.
When mixed with water, it forms a mortar with an exceptional wide range of applications. Emaco® Nanocrete R2 can easily be hand or trowel applied in thicknesses from 3 up to 100 mm.
Emaco® Nanocrete R3
Emaco® Nanocrete R3 is a single component,
lightweight, polymer modified, high build structural repair
mortar. Emaco® Nanocrete R3 is a ready-to-use
material that contains portland cement, well graded
sands, specially selected polymer fibres and additives.
Applied nanotechnology has been used to significantly
reduce shrinkage. Emaco® Nanocrete R3 has been
specifically formulated to produce a mortar with the
compressive strength and modulus characteristics
defined in class R3 of EN 1504 part 3. When mixed with
water, it forms a highly thixotropic mortar that can easily
be hand, trowel or spray applied in thicknesses up to 75
mm in one layer. It is particularly suited to vertical and
overhead work where hand-profiling is required.
Emaco® Nanocrete R4
Emaco® Nanocrete R4 is a single component, extra high-strength, high modulus, shrinkage compensated structural repair mortar that meets the requirements of the new European Norm EN 1504 part 3 class R4.
Emaco® Nanocrete R4 is a ready-to-use material that
contains Portland cement, well graded sands, specially
selected polymer fibres and special additives to
significantly reduce the risk and incidence of shrinkage
cracking. When mixed with water, it forms a highly
thixotropic mortar that can easily be spray or trowel
applied.
Emaco® Nanocrete AP
Emaco® Nanocrete AP active primer, not only reinstates a high pH environment it also contains active corrosion inhibiting additives for the protection of reinforcement steel. It can also be used as an adhesive bonding slurry for subsequent repair mortars. When mixed with water, it forms a slurry that can be applied by brush to the clean exposed reinforcement, or directly on the dampened, prepared concrete substrate when used as a bonding coat.